|
home | help | email |
|
  
|
||||||||
|
Some ICF programming files for W3OI Local Area If you have the Icom Programming software for you radio, you can download the ICF files below to speed up your programming. These files have the correct parameters for use of the W3OI Dstar repeater, along with some of the other nearby Dstar repeaters. In addition, most of the VHF and UHF regular Analog repeaters for this area are also included. To Use these files: 1) Load these ICF files into your program. 2) Put in your own FCC callsign into the MyCall field. 3) Then enter any message into the message fields. 4) Then, you may want to add or remove some of the analog repeaters, or change the name that is displayed on the screen to something you would rather see. For example, at the moment for the 146.700 analog repeater, the display name is DLARC -- you may want it to read W3OK... You may also want to come up with your own memory bank setup instead of what is now in these files. 5) Once you have made the changes do a "Save As" and give it a name that you prefer.
IC-2820H and ID-800H If you are using an IC-2820H or IC-800H, you can plug the programming cable into the PC and radio. Open the file you saved off your drive, and then go to the top menu bar, click "Clone" and then click "Write.
IC-91AD and IC-92AD To load into an IC-91 or an IC-92 you will need to do things a little different. A) Open the RS-91 or RS-92 software but MAKE SURE the radio is not connected to the cable. B) Open the appropriate ICF file you download from below, then follow steps 1 through 5 above. Once you have saved your changed file, close the program. C) Now you can plug your programming cable into the PC and radio. When it loads you will see there are two circular red arrows on an icon button near the top of the RS-91/RS-92 Screen. Do not do anything while these are colored Red (the program is reading all your radio information) --- wait until they turn to a Black color -- this may take two or three minutes --Once they are Black, now go to the top File menu, click "Open" and load the file you saved after editing it. D) As the file is opening you will get a message about saving changes -- click "No". E) Next you will get a message asking if you want to overwrite the Transceiver data -- Click "Yes" F) Those two arrows on the button near the top of the program will turn Red. again Don't do anything until they return to a Black color. Your HT is then programmed.
To Download the ICF Files, you will need to "Right-Click" the links below, and then select "Save As" or "Save Link As":
Copyright 2008 - ExecuTech Systems - All Rights Reserved |
|||||||||
